背钻设置(BACK DRILL).docVIP

Backdrill 如果net需要Backdrill, 需要给net设定Backdrill_max_pth_stub Property BACKDRILL_MAX_PTH_STUB Purpose Identification of nets targeted for backdrilling Usage Required Value Max allowable stub in length (database units) Objects Nets Backdrill analysis flag? ? S Backdrill_min_pin_pth 考虑可靠性, 必须保证BACKDRILL 后, 保证一定长度. Property BACKDRILL_MIN_PIN_PTH Purpose Ensures minimum pin plating depth is not compromised Usage Optional Value Length Objects Symbols, pins Backdrill analysis flag P 压接的接插件. 要保证良好的接触, 必须保证这个值. Property BACKDRILL_PRESSFIT_CONNECTOR Purpose Use on pressfit connectors to permit backdrilling from both sides of the board. Backdrill depth will not protrude into contact range as defined by the property string. Usage Optional Value value1:value2 where values = pin contact range; this value must be obtained from the manufacturer Objects Symbols Backdrill analysis flag n/a 有些不能用此功能的可以用此命令去掉. Exclusions It may be necessary to exclude certain objects from backdrilling even though stub violations are present. The BACKDRILL_EXCLUDE property can be applied to symbols, pins or vias at both the library and design level using Edit - Property. Common examples might include solder tail connectors or a dense pin escape pattern in BGA areas. The PCB designer should consult with a manufacturing engineer before assuming all pin/via objects are suitable for backdrilling. Property BACKDRILL_EXCLUDE Purpose Excludes objects from backdrilling even though stub may be present Usage Optional Value Boolean (true/false) Objects Symbols, pins, vias Backdrill analysis flag X 可以定义层 User Overrides In most cases, the backdrill layer ranges defined in the Backdrill Setup and Analysis user interface satisfy your requirements to manage stubs. The BACKDRILL_OVERRIDE property allows user-specified control of layer ranges for any pin or via and from ether side of the board or both. This is done regardless of violations that may result, such as testpoint conflicts or