RAS-100准同期使用说明书(V1.1)-Eng.docVIP

Operation Manual For RAS-100 Micro-processor-based Automatic Quasi-synchronizing Device V1.1 Acheng Relay Co., Ltd. Harbin, China April 2008  Operation Manual For RAS-100 Micro-processor-based Automatic Quasi-synchronizing Device V1.1 Compiled by: Chen Yanhe Checked by: Chen Zhenzhong Approved by: Sun Chengfa All rights reserved by：Acheng Relay Co., Ltd. Harbin Reli Electric Technology Co., Ltd. The specifications are subject to change without notice. When difference is found between the actual device and the specifications of the device in this manual, then the specifications shall be according to the actual device. Technical Support: Harbin Reli Electric Technology Co., Ltd.(Acheng Relay RD Center) Address: No.326 Xianfeng Road, Nangang District, Harbin City Telephone: 0086-4518002/3/4/5 Fax: 0086-4518001 Email: reli0451@163.com  Contents 1 Brief introduction 1 1.1 Front panel layout 1 1.1 Front panel layout 1 1.2 Descriptions for Rear Connection Terminals 2 2 Descriptions for Display and Keypad 4 3 Device menu operation 5 3.1 Monitor 6 3.2 Maintenance 8 3.3 Additional Descriptions 10 Thank you very much for your selecting our RAS-100 Micro-processor-based Automatic Quasi-synchronizing Device. Warning: 1) Do not insert or draw-out modules with power on. 2) When testing the device, reliable instruments shall be used. 3) In case that abnormality is found, please contact technical support. 1 Brief introduction 1.1 Front panel layout Fig. 1 RAS-100 Front panel layout diagram 1.1 Front panel layout The front panel layout is shown in Fig 1. On the front panel, 6 touch-keys are furnished. One 160×80 dot pattern LCD is furnished and also 9 LED indication lamps and one SIO communication port and one signal reset pushkey are provided. 36 LED indication lamps are provided to simulate synchronizing meter and one LED is used to indicate close permission. In operation state, the LCD shows the prompt menu and the curren