12c5a60s2实现AD转换.docVIP

//12c5a60s2实现AD转换 #includestc12c5a.h #includestdio.h #includeintrins.h #includemath.h //------------------------------------------------------------------------------ unsigned char disbuff[4={ 0,0,0,0,}; unsigned char posit=0; void AD_init(); void serial_init(); void delay(unsigned int a); float AD_work(unsigned char channel); unsigned intAD_get(unsigned char channel); void chu(long); #define uchar unsigned char sbit P2_0 = P2^0; sbit P2_1 = P2^1; sbit P2_2 = P2^2; sbit P2_3 = P2^3; unsigned char const discode[] ={ 0xC0,0xF9,0xA4,0xB0,0x99,0x92,0x82,0xF8,0x80,0x90,0xBF,0xff/*-*/}; void delay1(uchar i) { uchar j,k; for(j=i;j0;j--) for(k=125;k0;k--); } unsigned char bai,shi,ge,xi; long R; //------------------------------------------------------------------------------ void display() { disbuff[0]=S%1000/100; //更新显示 disbuff[1]=S%1000%100/10; disbuff[2]=S%1000%10 %10; if(posit==0) {P0=(discode[disbuff[posit]])0x7f;}//产生点 else {P0=discode[disbuff[posit]];} if(posit==0) { P2_1=0;P2_2=1;P2_3=1;} if(posit==1) {P2_1=1;P2_2=0;P2_3=1;} if(posit==2) {P2_1=1;P2_2=1;P2_3=0;} if(++posit=3) posit=0; } void main() { char k; int b=0; P0=0X00; AD_init(); //A/D转换初始化 serial_init(); //串口初始化 while(1) { unsigned char i; i=0;//P10口，i=n 则是P1n口 TI=1; chu(AD_work(i)); for(k=100;k0;k--) //使用printf函数前须先将发送标志位TI置1 display(); TI=0; } } //------------------------------------------------------------------------------ unsigned int AD_get(unsigned char channel) { ADC_CONTR=0x88|channel; //开启AD转换1000 1000 即POWER SPEED1 SPEED0 ADC_FLAG ADC_START CHS2 CHS1 CHS0 _nop_(); _nop_();_nop_(); _nop_();//要经过4个CPU时钟的延时，其值才能够保证被设置进ADC_CONTR 寄存器 while(!(ADC_CONTR0x10)); //等待转换完成 ADC_CONTR=0xe7; //关闭AD转换，ADC_FLAG位由软件清0 return (ADC_RES*4+ADC_RESL); //返回AD转换完成的10位数据(16进制) } //------------------------------------------------------------------------------ float AD_work(unsigned char channel) { double AD_val,A