题库-DFSS.docxVIP

i-Common DFSS methodologies1.A DMADV approach is appropriate in which of the following situations? A product or process is not in existence and one needs to be developed The current product/process exists and has been optimized but still doesnt meet customer and/or business needs The current product/process exists and meets customer and/or business needs, but has not been optimized?I only?I and II?I and III?I, II, and IIICurrent products that have not been optimized should first be addressed by improvement methods such as DMAIC before being targeted with re-design methods.2.When using the DMADV methodology, in the final phase you should do which of the following??Validate the assumptions used to design the product?Voice all concerns still remaining after the product has been designed?Visit customers to ensure designs are performing as intended?Verify design performance and its ability to meet customer needs3.The Optimize phase in certain DFSS roadmaps most nearly refers to the desire to do which of the following??Balance Quality and Cost?Fulfill all Customer Needs?Ensure Designs use standard materials?Provide full documentation of the Designs3.Some needs may not be possible to meet, others could only be met at a prohibitive cost.4.A Quick Service Restaurant chain routinely asks customers their opinions of food products during the design process. This is an example of which of the following??Design For Six Sigma?Robust Design?Design Verification?Failure Mode and Effects Analysis1.To generic a term, a more specific answer is preferred.2.Nonsense answer, the example is not oriented towards robustness.3.This example verifies the product is able to perform as designed.4.The process is not for the purpose of seeking problems, although negative feedback may prompt FMEA related activities.ii-Design for X (DFX)1.Design for Maintainability would most significantly affect which of the following metrics? MTTF MTBF MTTR?I?II?III?Neither I, II, nor III would be significantly affe