详解机》14第十四章应用帧中继实现广域网连接.pptVIP

Purpose: This figure continues the discussion of configuring subinterfaces. Emphasize: The Frame Relay service provider will assign the DLCI numbers. These numbers range from 16 to 992. This range will vary depending on the LMI used. Use the frame-relay interface-dlci command on subinterfaces only. Use of the command on an interface, rather than a subinterface, will prevent the device from forwarding packets intended for the DLCI. It is also required for multipoint subinterfaces for which dynamic address resolution is enabled. It is not used for multipoint subinterfaces configured with the fr