上汽通用别克汽车维修手册-12n.pdfVIP

SECTION 12N - FUSES, RELAYS AND WIRING HARNESSES IMPORTANT Before performing any Service Operation or other procedure described in this Section, refer to Section 00 CAUTIONS AND NOTES for correct workshop practices with regard to safety and/or property damage. 1. GENERAL INFORMATION 1.1 FUSES AND CIRCUIT BREAKERS All fuses and circuit breakers for VX Series carry over from that described in Section 12N FUSES, RELAYS WIRING HARNESSES in the VT Series I Service Information and the VT Series II Service Information, except as follows: 1. Fuse F5 STOP LAMPS in the passenger compartment fuse and relay panel assembly has been changed from 10 A to 15 A, refer to Fig. 12N-1. For all fuse and circuit breaker circuit protection details, refer to 1. POWER DISTRIBUTION circuit diagram in Section 12P WIRING DIAGRAMS of the VX Series Service Information. 1.2 RELAYS All information on relays for VX Series models carries over from that described in Section 12N FUSES, RELAYS WIRING HARNESSES in the VT Series I Service Information and the VT Series II Service Information, except as follows: 1. The resistance specifications for coils within the following relays has been revised from 93 ohms to 72 ohms to improve reliability and durability: Engine cooling fan (low) 5 pin Engine cooling fan (high) 4 pin Start 4 pin Blower 4 pin Blower inhibitor 4 pin EFI 4 pin Heated rear window 4 pin Power window 4 pin Headlamp high beam 4 pin 2.