ANSYS_离心压气机设计.pptVIP

Turbomachinery AnalysisHands-on Workshops Workshop 1 Geometry Creation Grid Generation for a Centrifugal Compressor Impeller BladeModeler Hands-On Example In this hands-on demonstration, you will: Create a centrifugal compressor impeller using Vista-CCD and BladeGen Export the necessary files for TurboGrid Import the impeller solid model into DesignModeler Starting BladeGen Start ANSYS Workbench Start Programs ANSYS 11.0 ANSYS Workbench On the Start Page, select Blade Geometry Vista-CCD To use the compressor design code, select File New Vista Centrifugal Compressor Design Vista CCD Compressor Duty Switch to the Duty and Aerodynamic Data tab Set overall pressure ratio, mass flow and rotational speed as shown Vista-CCD Geometry Switch to the Geometry tab and enter the settings shown below Click New Model to build the model When prompted, save geometry as filename Impeller.bgd Shroud Modification Select the shroud contour Right-click and select Segment Operations End Treatment… Click Tangent to Previous and Tangent to Next Click OK to close Shroud Modification Select the last point on the blade shroud contour Either right-click and select Segment Operations Point Location… or hit Shift-F2 to open the point dialog Shroud Modification Change the horizontal dimension to -9.9 Click OK to close the dialog Outlet Modification Select the outlet contour Hit Alt-F2 to open the point dialog Double-click on the points to change them as shown Trailing Edge Modification Select the trailing edge contour Double-click the shroud point on this contour to open the curve position dialog Select the “Stick to nearest segment end” checkbox Changing Leading Edge Ellipse Click the Blade Properties icon and click the LE/TE Ellipse tab Change the shroud ellipse ratio to 2.0 Hub Beta Modification Click and drag the first (leading edge) point to 55o Click and vertically drag the second point to 30o Click and vertically drag the 3rd and 4th points to 12o Shroud Beta M