旋锻对Mo-Ti-Zr合金性能及显微组织的影响-中南大学学报.PDFVIP

41 1 () Vol.41 No.1 2010 2 Journal of Central South University (Science and Technology) Feb. 2010 Mo-Ti-Zr ( 410083) Mo Ti Zr 99.35׃0.55׃0.10 1 920 28 mm Mo-Ti-Zr Mo-Ti-Zr Mo-Ti-Zr 1 250 33%Mo-Ti-Zr 98.5% (HRB)92.819.2%Mo-Ti-Zr Mo-Ti-Zr 1 250 33%Mo-Ti-Zr , 1 380 Mo-Ti-Zr TF125.2 A 1672−7207(2010)01−0097−06 Influence of rotary forging on mechanical properties and microstructure of Mo-Ti-Zr alloy LUO Ming, FAN Jing-lian, CHENG Hui-chao, TIAN Jia-min, LU Ming-yuan (State Key Laboratory of Powder Metallurgy, Central South University, Changsha 410083, China) Abstract: Mo-Ti-Zr alloy rods with diameter of 28 mm were prepared by mixing the elemental powders according to the mass ratio of m(Mo)׃m(Ti)׃m(Zr)=99.35׃0.55׃0.10, cold isostatic pressing and high temperature sintering at 1 920 , then the alloy rods were rotary forged. The influences of the rotary forging process on the relative density, hardness and microstructure of Mo-Ti-Zr alloy rods were investigated. The results are as follows. The relative density and hardness of Mo-Ti-Zr alloy rods increase gradually with the increase of deformation amount. The relative density of Mo-Ti-Zr alloy rods reaches 98.5% and hardness is HRB 92.8 after rotary forging to deformation amount of 33% at 1 250 . The increase of relative density of Mo-Ti-Zr alloy rods reaches the lowest after rotary forging to deformation amount of 19.2%. The fracture type of sintered Mo-Ti-Zr alloy rods is of intergranular fracture an