Gear Technology 目录.docVIP

Gear Technology 目录 Table of Contents 目录 Preface 前言 1. Introduction 引言 2, A Short Historical Sketch of the Development of Bevel and Hypoid Gear Technology 锥齿轮和准双曲面齿轮技术发展的历史梗概 2.1 Early developments by Gleason and Oerlikon 格里森和奥利康的早期开发 2.2 Klingelnberg Palloid method 克林根贝尔格摆线方法（palloid 查不到对应的中文译义，） Name of method Indexing method Tooth form Tool Cyclo-palloid Continuous Constant tooth Cutter head Palloid Continuous Constant tooth Conical hob 2.3 Development of the face cutterhead method 平面（切削面？）刀盘（或：铣轮）方法的发展 2.4 The introduction of hypoid offset in spatial bevel gearsets：advantages and disadvantages 立体锥齿轮组准双曲面补偿介绍:优点和缺点 2.5 Cutterhead tilt 刀盘（或：铣轮）倾斜 2.6 Gear machines with degrees of freedom for modern corrections 具有现代校正自由度的齿轮机 2.7 Numerically controlled machines with electronic drives 电子驱动数控机床 2.8 Alternative gear machine concepts 可供选择的齿轮机概念 2.9 The fully numerically controlled universal machines 完全数控通用机床 2.10 The different types of face cutterheads 不同类型的切削面刀盘（铣轮？） 2.11 Literature 文献 3．Basic Geometric and Kinematic Principles of Spiral Bevel and Hypoid Gears 螺旋锥齿轮和准双曲面齿轮的基本几何学的和运动学的原理 3.1 Basic gear types with uniform tooth depth - exact tooth systems 具有均匀齿高的基本的齿轮类型——精确齿系统 3.2 Basic gear types with tapered tooth depth - octoids of the first and second kind 具有锥形齿高的基本的齿轮类型——第一和第二型冠齿轮（奥克托齿？） 3.3 Flank form and flank angle deviations on tooth systems with tapered tooth depth 关于具有锥形齿高的齿轮系统的下齿面（齿腹？齿侧？）形式和下齿面（侧面？）角度偏差 3.4 Comparison of the characteristics of the classical Gleason and 0erlikon methods 古典格里森和奥利康方法的特征比较 3.5 Literature 文献 4. Calculation System for the Analysis of Spiral Bevel Gearsets 螺旋锥齿轮组的分析计算系统 4.1 Calculation interfaces and flank generation 计算接口和下齿面（齿腹？齿侧？）生成 4.2 Load-free tooth contact analysis 无负荷的轮齿接触分析 4.3 Generating Structures and Calculation of Loading Division and Loading Distribution 荷载分割和荷载分布的生成结构和计算 4.4 Calculation of stress distribution 应力分布的计算（或：