BEAedo讨改.docVIP

BEA Tuxedo+ WebLogic编程简介 BEA Tuxedo+ WebLogic编程简介 1 一、 BEA Tuxedo 简介 1 二、BEA Tuxedo配置文件UBBCONFIG 3 三、BEA Tuxedo常见配置错误 6 四、BEA Tuxedo常用命令 7 五、常用BEA Tuxedo函数： 8 六、常见错误分析： 18 BEA Tuxedo 简介 关于UBBCONFIG文件的一些设置： The cost incurred by increasing MAXACCESSERS is one additional semaphore per site per client or server process (accesser—see note that follows). There is a small fixed semaphore overhead for system processes in addition to that added by the MAXACCESSERS value. The cost of increasing MAXSERVERS and MAXSERVICES is a small amount of shared memory that is kept for each server, service, and client entry,respectively. The general idea for these parameters is to allow for future growth of the application. It is more important to scrutinize MAXACCESSERS. Note: The system allocates one semaphore for each access slot to the bulletin board. A semaphore is a latch circuit that prevents more than one process from accessing the same shared memory in the bulletin board at the same time. For BEA Tuxedo pre-Release 7.1 (6.5 or earlier), both the MAXACCESSERS and MAXSERVERS parameters for an application play a part in the user license checking scheme. Specifically, a machine is not allowed to boot if the number of MAXACCESSERS for that machine + the number of MAXACCESSERS for the machine (or machines) already running in the application is greater than the number of MAXSERVERS + user licenses for the application. Thus, the total number of MAXACCESSERS for an application must be less than or equal to the number of MAXSERVERS + user licenses for the application. First of All ——— 设置合理的操作系统核心参数！！ # 用tmunloadcf generated.ubb 可以得出目前配置得UBB文件所有得参数值（没有设置的有缺省值） # 用tmloadcf –c或tmboot –c可以计算出当前UBB配置的Tuxedo启动最少要占用的系统IPC资源。 Ipc sizing (minimum /T values only) ... Fixed Minimums Per Processor SHMMIN: 1 SHMALL: 1 SEMMAP: SEMMNI Variable Minimums Per Processor SEMUME, A SHMMAX SE