PEJ-600×900简摆颚式破碎机设计.doc

简摆颚式破碎机设计 摘 要：×900。然后本文对颚式破碎机的主要零部件包括推力板、连杆、动颚、偏心轴、皮带轮等进行了设计和校核。此外也简单介绍了颚式破碎机的主要部件的安装、颚式破碎机的The Design of Simple Pendulum Jaw Crusher Abstract: This paper mainly targets the design of simple pendulum jaw crusher, through understanding the development of its status in domestic and foreign, comparing advantages and disadvantages of simple pendulum and compound pendulum and other jaw crushers, an escellent performance simple pendulum is designed. This paper introduces jaw crusher's development status and the significance of research, through comparative analysis, an overall program of simple pendulum jaw crusher is determined; and then it expounds the working principle and characteristics of simple pendulum jaw crusher, analyses the structure of the main components, which include insurance devices , adjustment devices, rack structure ,lubrication device and so on; later it computs parameters of the machine (spindle speed, capacity, crushing strength, power and so on ) , thus the model of PEJ-600×900 is determined. Next the design verification includes a thrust plate, link, moving jaw, eccentric shaft, pulley and other important components. In addition, a brief introduction of the jaw crusher installation of major components, jaw crusher equipment failure analysis and treatment measures. Key words：imple pendulum jaw crusher; check; design目 录 1 绪论 1 1.1 选题背景 1 1.2 课题的意义 2 1.3 研究的内容，采用的方法与步骤 2 2 概述 3 3 颚式破碎机的工作原理及类型 5 3.1 简摆颚式破碎机 5 3.2 复摆颚式破碎机 8 3.3 综合摆动型颚式破碎机 9 3.4 其他类型颚式破碎机 9 3.5 颚式破碎机的选择 10 4 主要零部件的结构分析 11 4.1 连杆 11 4.2 动颚 11 4.3 齿板的结构 12 4.4 肘板 12 4.5 调整装置 13 4.6 保险装置 14 4.7 机架结构 14 4.8 传动件 15 4.9 飞轮 16 4.10 润滑装置 16 5 简摆颚式破碎机的主参数计算 17 5.1 给矿口尺寸确定 17 5.2 钳角 17 5.3 动颚摆动行程与偏心轴的偏心距 18 5.4 主要构件尺寸的确定 19 5.4.1 破碎腔高度H 19 5.4.2 偏心距r对连杆长度l的比值λ 19 5.4.3 推力板长度K 19 5.5 主轴转速 20 5.6 生产能力 21 5.7 破碎力和破碎功率的计算 22 5.7.1 最大破碎力 22 5.7.2 功率的计算 22 6 主要零部件的设计及校核 23 6.1 电动机的选择 23 6.2 V带传动设计 23 6.3 推力板的受力分析及校核 24 6.4 连杆的受力分析 25 6.5 动颚的受力分析及校核 25 6.