12V电机调速器可逆.docxVIP

Wide Voltage Multi Reversible governor HXZF-1Connection Ports:A main power ports:VCC positive supply DC12-60V.GND Negative , if you want to reduce the external interference shielding box connected to terminals or here at the cathode connected to the power supplyM + motor positiveM- motor negativeSecond, the control port :5V: driver board internal 5V power supply, the output capacity of less than 100mA, with potentiometer mode is recommended only to use , do not drive other circuitsPWM: external PWM control signal input level range ,3-20V , 2mA current requirements ;ADJ: external 0-5V or 0-10V control signal inputGND: ground control signals , such as the shield shell is not allowed to pick pick here is also not allowed in this place other circuits connected GND,DOWN: control signal, the internal coupler control signal and GND effective turn ( optocoupler turns on, can also be used microcontroller , NPN switch control )UP: control signal, the internal coupler control signal and GND effective turn ( optocoupler turns on, can also be used microcontroller , NPN switch control )STOP: control signal, the internal coupler control signal and GND effective turn ( optocouplerturns on, can also be used microcontroller , NPN switch control )Third, the mode setting :1, M1 = short , M2 = open circuit mode 1 ; potentiometer voltage three-stage control + STOP allowed to runSTOP LOW can control the motor ,After the input voltage of 2.5V , the motor stops ; Usually this range 2.4-2.6 , for interference .2.5 gradually accelerated to 0V reverse rotation ,2.5-5V forward speed rotation ; That middle position potentiometer stops on both sides of adjustment on both sides of the motor speed .2, M1 = open , M2 = short circuit, Mode 2 ; potentiometer voltage + DOWN state control Reversible , STOP allowed to run( The default value for this speed mode )STOP low ( short circuit to GND on ) is enabled, the driver can control the motor voltage and DOWN signals ; high motor brake stops , the voltage