汽车三角玻璃窗包胶模具.pptVIP

 三 角 窗SAIPA Window Product Assembly Drawing Operation Instruction Assembly Drawing * 680mm 1530mm 600mm 640mm 243.5mm 670mm 420mm １.開上模，同時上板上鑲件在彈簧及自重作用下，下落25mm。取出水口。 Open the mold The insert on upper plate goes down 15mm via spring and its weight. Take out the spider. at least 120mm 001 sensor 電眼 sensor 電眼 048 047 002 Cylinder1 Cylinder2 3.下模由機器推出 The lower mold is pushed via press. 4. Cylinder1. Cylinder2活塞杆向箭頭方向運動60mm，帶動018A,018B.020A.020B運動, （同時産品隨018升起） Piston-rod of cylinder 12 move 60mm as to arrowhead direction, and part 018A, 018B, 020A,020B move accordingly. (The product goes up with part 018 together) Cylinder 2 Cylinder 1 5.取出産品。同時産品隨018升起 Take out the product 6 . Cylinder 1, Cylinder 2活塞杆向箭頭方向運動60mm,(同時018A.018B在彈簧作用下,下降合模.020A.020B分別合模) Piston-rod of cylinder 1 2 move 60 mm as to arrowhead direction. At the same time, Part 018A and 018B go back via spring. And Part 020A and 020B go back separately. Cylinder 1 Cylinder 2 7.下模由機器油缸推入 The lower mold is pushed back via press. 8.合上下模 Closed the mold. （一）upper plate 基準角 Pls. refer to this angle to assemble the mold Spring SML25-30 （二）Middle plate ?18x17Tapered Interlocks 基準角 Pls. refer to this angle to assemble the mold Disc spring DS15-6.2-0.7 Disc spring DS15-6.2-0.7 Disc spring DS15-6.2-0.7 Disc spring DS15-6.2-0.7 Sensor 電眼 Assemble spring (16 places) TL22-70F28 （三）Bottom plate Cylinder 1 Cylinder 2 基準角 Pls. refer to this angle to assemble the mold 049B 049A Assembly spring (6 places) SML25-30F12 2-062 2-053 當生産10万件産品時候,請檢查049A . 049B.054.062是否磨損.檢查所有壓縮彈簧是否能復原 (請更換模具配件） After 100,000pcs, pls. check Part 049A, 049B, 054, 062 and springs. If it is necessary, pls. replace them. 2-054 4-055 2-057 048 基準角 Pls. refer to this angle to assemble the mold 062 Cylinder Assembly Instruction 2-057 1.安裝057,前後各一件(配4-M5）螺絲. Assemble part 057 (1pc each in both front and rear ) with 4-M5 screw. 2.安裝060,前後各4件. Assembly 060 ( 4pcs each both in front and rear) 047 048 3.安裝061至油缸活塞杆 Assembly part 061 on t