Hand and Power Tool Safety 08 （一）.pptVIP

* 1926.301 ? If a screwdriver is used as a chisel, the tip of the chisel may break and fly off, hitting the user or other employees. ? If a wooden handle on a tool, such as a hammer or an axe is loose, splintered, or cracked, the head of the tool may fly off and strike the user or other employees. ? If the jaws of a wrench are sprung, the wrench might slip. ? If impact tools, such as chisels, wedges, or drift pins have mushroomed heads, the heads might shatter on impact, sending sharp fragments flying toward the user or other employees. * 1926.300(c) and (a) and 1926.25 Provide the necessary PPE to employees using hand and power tools to protect them from hazards of falling, flying, abrasive, and splashing objects, or exposure to harmful dusts, fumes, mists, vapors, or gases. * 1926.300(b) and 1926.302 * 1926.300(d) Switches Use on-off control: hand-held powered platen sanders, grinders with wheels 2-inch diameter or less, routers, planers, laminate trimmers, nibblers, shears, scroll saws, and jigsaws with blade shanks one-fourth of an inch wide or less Use momentary contact on-off control and may have a lock-on control provided that turnoff can be accomplished by a single motion of the same finger or fingers that turn it on: hand-held powered drills, tappers, fastener drivers, horizontal, vertical, and angle grinders with wheels greater than 2 inches in diameter, disc sanders, belt sanders, reciprocating saws, saber saws, and other similar operating powered tools. Use a constant pressure switch which shuts off power when released: All other hand-held powered tools, such as circular saws, chain saws, and percussion tools without positive accessory holding means * * 1926.302(a)(2) * 1926.302 (a)(1) Three-wire cords contain two current-carrying conductors and a grounding conductor. Any time an adapter is used to accommodate a two-hole receptacle, the adapter wire must be attached to a known ground. The third prong must never be removed from the plug. Doubl