ANSYS ICEM资料--B2-WS-3DPipes.ppt

6/18/04 ICEM CFD / AI*Environment 5.0 6/18/04 ICEMCFD/AI*Environment Tetra Workshop 1 3D Pipe Junction Create Project Import Geometry Select File Import Geometry ParaSolid Browse to 3DPipeJunct Select pipes.x_t and select Open Move the geometry on the screen (only curves are displayed by default) Left mouse button – 3D screen rotate Middle mouse button – Translate Right mouse button – left/right 2D screen rotate; up/down zoom in/out Build Topology Create Parts for Surfaces Create Parts Right-click on Parts and select Create Part Enter pipe1 as Part name Choose Create Part by Selection Toggle selection filters so only surfaces are selectable Select the two surfaces describing the small cylinder inside the largest half-cylinder Create Parts for Surfaces Create Parts Continue Part creation for surfaces as shown Material Points Clean Parts, Colors Clean up Parts Right-click on Parts and select Delete Empty Parts Right-click on Parts and select Good Colors Right-click on a Part name and select Modify Color for additional color adjustments File - Save Project Global Mesh Size Mesh Size Tetra defaults to Global Element Seed Size unless other parameters cause subdivisions Sizes can be set on geometry entities Mesh - Set Global Mesh Size Set Scale factor to 5 Set Max element to 2 Toggle on Display for representative element sizes Surface Mesh Size Surface Mesh Size Specify the Maximum element size by Part Can also select individual surfaces Mesh - Set Surface Mesh Size From the Select geometry window pick Select items in a part (Key = Shift-P) Select parts – OUTLET, PIPE1_CAPS, PIPE2, SYMM and Accept Set Maximum element size to 2 and Apply Select parts – INLET, PIPE1, PIPE3 and Accept Set Maximum element size to 1 and Apply Enable Tetra Sizes option for Surfaces display Save project Tetra Meshing Tetra Meshing Mesh - Mesh Tet Select From geometry for Method Use other defaults (mesh is smoothed) Apply Mesh loads upon completion Expand the Mesh branch Right-click on Shel