Advanced Tuning Products Inc英文资料.pdfVIP

Advanced Tuning Products Inc. Document Number: INS-PRO-008-A Page 1 of 7 Procedure: Installation for the GT28RS Turbo Upgrade for the Transverse Mounted 1.8T Golf/Jetta/GTI/Beetle Model Years 2000 to 2004 Warning: Check local laws before adding turbo components to your vehicle. Some states prohibit the addition of an aftermarket turbo system on emissions controlled vehicles. Parts Checklist (Bill Of Materials): 1) Turbo Inlet Pipe Set 1. Input pipe with hose nipples 2. 90 Degree Inlet Elbow (2.5” to 3”) with 2 T-bolt Clamps 3. Silicone Transition connector (2.5” to 2.75”) with 2 Screw type clamps 2) High Flow Cast Exhaust Manifold with hardware 1. Turbine Inlet gasket 2. 4 8mm studs and locking nuts 3. Block-off plate for external waste-gate port, gasket, 8mm studs and locking nuts 3) GT28RS Turbocharger unit fully clocked and assembled with basic hardware 1. Silicone Connector 2” on outlet with 2 clamps 2. Waste-gate actuator with bracket mounted in place with e-clip 3. Set of (5) 8mm studs, nuts, and washers for turbine discharge (no gasket required) 4) V-band turbine discharge adapter (5 bolt to 3” V-band Adapter) 5) V-band Clamp 3” 6) 3” Stainless Downpipe Assembly with hardware 1. V-band flanged turndown pipe 2. Center section with flex tubing 3. Rear race section to mate to exhaust 4. Exhaust gaskets, nuts and bolts to join the three sections Advanced Tuning Products Inc. Document Number: INS-PRO-008-A