Two dimensional photoacoustic imaging by use of Fourier transform image reconstruction and a detector with an anisotropic response英文文献.pdfVIP

Two-dimensional photoacoustic imaging by use of Fourier-transform image reconstruction and a detector with an anisotropic response Kornel P. Ko¨ stli and Paul C. Beard Theoretical and experimental aspects of two-dimensional 2D biomedical photoacoustic imaging have been investigated. A 2D Fourier-transform-based reconstruction algorithm that is significantly faster and produces fewer artifacts than simple radial backprojection methods is described. The image- reconstruction time for a 208 482 pixel image is 1 s. For the practical implementation of 2D photoacoustic imaging, a rectangular detector geometry was used to obtain an anisotropic detection sensitivity in order to reject out-of-plane signals, thereby permitting a tomographic image slice to be reconstructed. This approach was investigated by the numerical modeling of the broadband directional response of a rectangular detector and imaging of various spatially calibrated absorbing targets im- mersed in a turbid phantom. The experimental setup was based on a Q-switched Nd:YAG excitation laser source and a mechanically line-scanned Fabry–Perot polymer-film ultrasound sensor. For a 800 m 200 m rectangular detector, the reconstructed image slice thickness was 0.8 mm up to a vertical distance of z 3.5 mm from the detector, increasing thereafter to 2 mm at z 10 mm. Horizontal and vertical spatial resolutions within the reconstructed slice were approximately 200 and 60 m, respec-