某热电工程烟囱专项施工方案及烟囱基坑支护方案.docVIP

******热电烟囱工程 施 工 组 织 设 计 编制单位：***工程建设承包有限公司 编制日期：2009年2月22日 目 录 第一章 工程概况··················································3 第二章 整体施工顺序··············································3 第三章 施工方法及施工程序········································3 第四章 主要分项工程的施工········································5 1）内钢管架、平台及提升系统安装施工································5 2）烟囱的钢筋砼施工················································7 3）烟囱附件施工····················································13 4）烟囱装饰施工····················································13 5）钢管架的拆除施工················································14 6）沉降观测施工····················································14 7）特殊气候施工····················································14 第五章 工程所需的主要材料········································14 1）工程所需的主要建筑材料··········································15 2）工程所需的主要措施材料·········································15 3）工程所需工程具计划·············································16 第六章 施工进度计划·············································18 第七章 劳动力计划···············································18 第八章 质量、安全保证措施·······································18 1）质量保证措施···················································18 2）安全保证措施···················································19 第九章 施工进度表···············································23 第十章 基坑支护方案·············································23 一、工程概况 该工程为100m钢筋混凝土烟囱工程，上部出口内径为3m，筒身采用现浇钢筋混凝土“竖井架移模法”施工，内衬耐酸砖砌体，筒首设花格装饰及刷航空标志色环。烟囱外设直爬梯，顶部钢平台设信号及避雷等附属设施。 主要工程数量如下表所示： 序号 部　　位 材料名称 单位 数量 1 烟囱基础垫层 C10混凝土 M3 15 2 烟囱基础 C30混凝土 M3 195 3 烟囱筒身 C30混凝土 M3 525 二、整体施工顺序 烟囱基础挖土方、垫层、基础砼施工，周边回填，烟囱上升的准备工作，烟囱±0.000到第一层平台施工，第二层平台到100m（含囱帽）施工。钢管架拆除施工，隔烟墙及漏斗平台施工，油漆防腐及标志环施工。 三、施工方法及施工程序 　　本钢筋砼塔囱的施工方法主要采用“钢管架移置模板倒模法”施工。方法是：将钢管架立于筒身中，顶部设单层操作平台，作为砌砖、钢筋、模板、采用一套模板逐节提升、安装、拆卸，将筒身砼逐节段分层浇筑的方法。 施工顺序如下所示： 四、主要分项工程的施工 1．钢管架、平台及提升系统安装施工 1．1井架安装施工 　　内部垂直提升钢管架高6m，采用钢管脚手架搭设，站杆水平步距1.5m，水平横杆竖向步距1.15m，按烟囱内径的收比度进行搭设，内架直径随内衬尺寸逐渐减小（内钢管架的验算见后附件一）。搭设钢管架时，要将钢管两端伸入囱体中（见下图：详A）。在高度方向，每隔