时钟程序.docVIP

#includereg52.h #define uchar unsigned char #define uint unsigned int sbit dula=P2^6;//定义锁存器锁存端 sbit wela=P2^7; sbit s1=P3^4;//定义功能键 sbit s2=P3^5;//定义增加键 sbit s3=P3^6;//定义减小键 sbit s4=P3^7;//闹钟查看键 sbit beep=P2^3;//蜂鸣器 sbit d1=P1^0; sbit sda=P2^0; sbit scl=P2^1; uchar a; void delay0() { ;; } void start() //开始信号 { sda=1; delay0(); scl=1; delay0(); sda=0; delay0(); } void stop() //停止 { sda=0; delay0(); scl=1; delay0(); sda=1; delay0(); } void respons() //应答 { uchar i; scl=1; delay0(); while((sda==1)(i250))i++; scl=0; delay0(); } void init24c02() { sda=1; delay0(); scl=1; delay0(); } void write_byte(uchar date) { uchar i,temp; temp=date; for(i=0;i8;i++) { temp=temp1; scl=0; delay0(); sda=CY; delay0(); scl=1; delay0(); scl=0; delay0(); } scl=0; delay0(); sda=1; delay0(); } uchar read_byte() { uchar i,k; scl=0; delay0(); sda=1; delay0(); for(i=0;i8;i++) { scl=1; delay0(); k=(k1)|sda; scl=0; delay0(); } return k; } void write_add(uchar address,uchar date) { start(); write_byte(0xa0); respons(); write_byte(address); respons(); write_byte(date); respons(); stop(); } uchar read_add(uchar address) { uchar date; start(); write_byte(0xa0); respons(); write_byte(address); respons(); start(); write_byte(0xa1); respons(); date=read_byte(); stop(); return date; } char code table[]={ 0x3f,0x06,0x5b,0x4f, 0x66,0x6d,0x7d,0x07, 0x7f,0x6f,0x77,0x7c, 0x39,0x5e,0x79,0x71}; char count,s1num,flag,shi,fen,miao,shi1,shi2,fen1,fen2,miao1,miao2; char cshi,cfen,cmiao;//闹钟设定的变量值 void delay(uint z)//延时函数 { uint x,y; for(x=z;x0;x--) for(y=110;y0;y--); } void init()//初始化子函数 { miao=0;miao1=0;miao2=0;//初始化秒分时变量值 fen=0;fen1=0;fen2=0; shi=0;shi1=0;shi2=0; count=0;flag=0; s1num=0; init24c02(); cmiao=read_add(1);//首次上电从AT24C02中读取出存取的数据 delay(100); cfen=read_add(5); delay(100); cshi=read_add(10); delay(100); TMOD=0x01;//设置定时器0工作模式1 TH0=(65536-50000)/256;//定时