ConfiguringLinkAggregationwithEtherChannel文件材料.ppt

Cisco Network Academy. All rights reserved.. CCNP+ BSMSN v3.0 Cisco Network Academy. All rights reserved.. CCNP+ BSMSN v3.0 Implementing Spanning Tree Configuring Link Aggregation with EtherChannel EtherChannel Logical aggregation of similar links Load balances Viewed as one logical port Redundancy Configuring Layer 3 EtherChannel Switch(config)#interface port-channel port-channel-number Creates a port-channel interface Switch(config-if)#no switchport Switch(config-if)#ip address address mask Specifies L3 and assigns an IP address and subnet mask to the EtherChannel Switch(config-if)#no switchport Switch(config-if)#channel-group number mode {auto | desirable | on} Configures the interface as L3 and specifies the port channel and the PAgP mode Switch(config)#interface interface slot/port Specifies an interface to configure Verifying EtherChannel Switch#show running-config interface port-channel num Displays port-channel information Switch#show run interface port-channel 1 Building configuration... Current configuration : 66 bytes ! interface Port-channel1 switchport mode dynamic desirable end Switch#show running-config interface interface x/y Displays interface information Switch#show run interface gig 0/9Building configuration... Current configuration : 127 bytes ! interface GigabitEthernet 0/9 switchport mode dynamic desirable channel-group 2 mode desirable channel-protocol pagp end Verifying EtherChannel (Cont.) Switch#show interfaces gigabitethernet 0/9 etherchannel Port state = Up Mstr In-Bndl Channel group = 1 Mode = Desirable-Sl Gcchange = 0 Port-channel = Po2 GC = 0 Pseudo port-chan