[工程科技]汽车发动机右支架加工工艺毕业设计.doc

摘 要 大多数发动机关键零部件技术还掌握在跨国公司手中，我们的发动机技术水平与世界新进水平相比还有不小的差距关键词： ；；Abstract In recent years, with the external technical beening massively introduced, the domestic automobile profession has been rapidly obtained developed.The right support is the main parts on the “engine”棗the automobile heart.a The manufacture precision and the complex component requests shape bring a lot of inconvenient during the process. This design researches systematically on the engine right support processing craft and the jig. In the processing craft aspect the processing method that the working procedure centralism and the dispersed phase are combined is used, and the numerical control engine beds is used to process centrally the partial working procedures, then, not only the processing quality is guaranteed, but also the production efficiency is greatly enhanced .At the same time, the former hole surface processing is innovated in the processing working procedure successively the order which causes the localization to be more accurate, thus also enable the components the processing precision to obtain a better guarantee.In the jig design aspect, in each working procedure the unit clamp is used to carry on the clamp nearly to the work piece, and in partial working procedures, the elastic localization is used to overcome the work piece distortion during clamps produces and the the pre-folk prescription law is used to solve the middle axle distortion during bracket processing. While the special clamp is design, the complex component shape and the few choice location are taken into account, the right support bottom surface is taken as the fine datum, and two positioning pins and four supporting tablet couplet are used to locate completely, the hydraulic pressure clamp method is selected and two belt spiral groove hooks are used to clamp work piece, which not only ensure the processing precision and the production efficiency, but also enhanced the production security and the working conditions. T