[工程科技]DeviceNet温度变送器通信接口的设计.docVIP

摘 要 DeviceNet现场总线是网络技术控制领域的一种低成本、高性能的网络技术，它的物理层和数据链路层是与CAN2.0协议一致的。数据链路层协议是由CAN控制器来实现。DeviceNet现场总线中的每一个设备都是由它的对象模型来描叙，每个模型中的对象由类属性所描述，利用预定义主/从连接标志符，DeviceNet可以简化I/O转换以及资源的配制。I/O信息是用来控制数据的相关性和实时信息控制，通过外在信息携带配制并诊断网络节点，传输信息使用的是生产者/消费者模式。 本论文设计的这个DeviceNet温度变送器，DeviceNet节点选用的是8位微处理器W78E58，并采用CAN控制器SJA1000，软件设计包含对象建模和数据链路层的设计，所有的对象都在对象模型里被定义了，并且初始化了它们的参数，协议由ANSI C执行，语句与DeviceNet的规格一致，硬件还包含了电路图的设计。 关键字：现场总线；网络技术控制领域；温度变送器；A/D转换器。 Abstract DeviceNet is one of low-cost and high-capability based on Control Area. Network technology. Its physical layer and data link Layer were in accordance with CAN 2.0 protocol, data link layer protocol was realized by CAN controller. Each device within a DeviceNet network is represented by object model, each object in model is represented by class-instance-attribute. With the predefined Master/Slave connection set identifier, DeviceNet simplify the exchange of I/O and configuration data, I/O message is used to the data correlation with control and real-time message, explicit message carrys the configuring and diagnosing data of nodes. The transmission of messages use producer/consumer model..This paper designs the intelligence tramsmitter, The node uses the 8 bits microprocessor W78E58 as data processor, and adopts the CAN controller SJA1000, software include the Object modeling and data link layer programming. all of object in object model was defined and initialized the parameter. the Protocol implemented by ANSI C, Sentences in accord with DeviceNet Specifications, the hardware include the design of Schematic and PCB. in the end, emulating hardware and debugging software. the intelligent transmitter can transmitted the analog signals to data signals, which realized the network digitization, intellectual. Key words: Fieldbus; control Area Network; temperture transmitter; A/D transition. 目 录 1. 绪论…………………………………………………………………………………………() 1. 1课题背景………………………………………………………………………………() 1. 2本论文所做的工作……………………………………………………………………() 2. 现场总线的国内外发展现