一种新型气固分离器气相流场试验研究-高校化学工程学报.pdfVIP

20 6 No.6 Vol.20 2006 12 Journal of Chemical Engineering of Chinese Universities Dec. 2006 1003-9015(2006)06-0875-07 , , (() , 102249) 10~22 m⋅s− 1 31%41%28% TQ028.24 X701.2 Experimental Research of the Flow Field in a Novel Gas-Solids Separator LIU Xian-cheng, LU Chun-xi, SHI Ming-xian (State Key Laboratory of Heavy Oil, China University of Petroleum, Beijing 102249, China) Abstract: A new type of catalyst regeneration technique combining the post coke-burning riser and the conventional turbulent bed regenerator was proposed previously. One of distinct features of the technique is the arrangement of the gas-solid separator which is located at the outlet of the riser, where it may bring forth some advantages such as the simple structure, the higher separation efficiency, the lower pressure drop, and flexible operation. To meet these requirements, a novel gas-solid separator incorporating the inertial and the centrifugal separation mechanism was figured out. Based on the previous study on the structural optimization and the performance investigation, the flow field of the proposed separator was studied by using five-hole probe under the operating condition of the inlet gas velocity 10~22 m⋅s− 1. The main characteristic of this type separator is that gas flowing around the central pipe is mainly along tangential direction, the closer to the central pipe the higher the velocity is. Based on the experimental results, the structure advantages and disadvantages were discussed. At the same time, the proportions of gas flux passing through the slots and under central pipe