2013年《电路与电子技术》(双语)试卷A.docVIP

诚信应考,考试作弊将带来严重后果！不允许携带任何电子设备 华南理工大学期末考试 《电路与电子技术》（双语）试卷A 考试时间：120 minutes 注意事项：1. 考前请将密封线内填写清楚； 2. 所有答案请直接答在试卷纸上； 3．考试形式：闭卷； 4. 本试卷共三大题，满分100分， 考试时间120分钟。 题 号 I II III 总分 满分 20 40 40 100 得 分 评卷人 I. Short answer questions (20 points) Explain the following abbreviations meaning KVL: Op amp: BJT: NMOS 2、Determine ix and v x in the circuit of Fig. 1.2. Figure 1.2（中文版 21页） 无详细解答 3、Find the power absorbed by each element in the circuit in Fig.1.3. Fig. 1.3 4、Using repeated source transformations, determine the Norton equivalent of the highlighted network in the circuit of Fig. 1.4. Fig. 1.4（中文版94页） 无详细解答 5、Simplify the network of Fig.1.5a using series/parallel combinations. Figure 1.5 (a) A given LC network. (b) A simpler equivalent circuit (中文版128页) 有详解 II. Calculation and analysis of problems (40 points) 6. What is the power dissipated in the 2-? resistor in Fig.2.6. Figure 2.6（中文版104页） 课后习题 11题 看课后习题答案 7. In the frequency-domain circuit of Fig.2.7, find (a) I1; (b) I2; (c) I3. Figure 2.7.（中文版 196页） 无详细解答 8. Find the node voltages phasor V1 and V2 in the circuit shown in Fig.2.8. Figure2.8 A frequency-domain circuit for which node voltages V1 and V2 are identified. （中文版 198页） 有详细解答 9. For the circuit of Fig.2.9, find the indicated currents and voltages throughout the circuit and calculate the total power dissipated in the load. Figure2.9（中文版252页） 有详细解答 III. Design and application of question (the following questions optional 4 questions) 10. A power-supply circuit is needed to deliver 0.1A and an average of 15V to a load. The ac source available is 110V rms with a frequency of 60 Hz. Assume that the full-wave circuit of Figure 3.10 is to be used with a smoothing capacitor in parallel with the load. The peak-to-peak ripple voltage is to be 0.4V. Allow 0.7V for forward diode drop. Find the turns ratio n that is needed and the approximate value of the smoothing capacitor