ATM 点到点配置.docVIP

ATM 点到点配置 2010-05-08 09:42:54 　标签：ATM 到点　　　 [推送到技术圈] ATM 点到点配置 很多爱好网络的人员，对ATM都感觉到陌生，因为没有ATM交换机，而无法进行实验，DynamipsGUI也能进行ATM的实验，下面是通过这个软件进行的ATM配置，希望能帮助大家来学习ATM。 在此实验中路由器RA、RB、RC通过ATM交换机相连，他们之间是通过VC进行交换数据，具体VC如拓扑图所示。在此拓扑中采用的是OSPF动态路由协议。 具体配置如下： RouterA#sh running-config Building configuration... Current configuration : 1248 bytes ! version 12.4 service timestamps debug datetime msec service timestamps log datetime msec no service password-encryption ! hostname RouterA ! boot-start-marker boot-end-marker ! ! no aaa new-model ! ! ip cef ! ! ! ! interface Loopback0 ip address ! interface FastEthernet0/0 no ip address shutdown duplex half ! interface ATM1/0 no ip address no atm ilmi-keepalive ! interface ATM1/0.20 point-to-point ip address ip ospf network point-to-point no snmp trap link-status pvc 10/10 protocol ip broadcast encapsulation aal5snap ! ! interface ATM1/0.30 point-to-point ip address ip ospf network point-to-point no snmp trap link-status pvc 11/11 protocol ip broadcast encapsulation aal5snap ! ! interface ATM2/0 no ip address shutdown no atm ilmi-keepalive ! router ospf 10 log-adjacency-changes network 55 area 0 network 55 area 0 network 55 area 0 ! ! no ip http server no ip http secure-server ! ! ! ! ! ! control-plane ! ! ! ! ! ! gatekeeper shutdown ! ! line con 0 exec-timeout 0 0 stopbits 1 line aux 0 stopbits 1 line vty 0 4 ! ! End RouterB#sh running-config Building configuration... Current configuration : 965 bytes ! version 12.4 service timestamps debug datetime msec service timestamps log datetime msec no service password-encryption ! hostname RouterB ! boot-start-marker boot-end-marker ! ! no aaa new-model ! ! ip cef ! ! ! ! ! ! interface Loopback0 ip address ! interface FastEthernet0/0 no ip address shutdown duplex half ! interface ATM1/0 ip address ip ospf network point-to-point no atm ilmi-keepalive pvc 20/20 protocol ip broadcast protocol ip broadcast encapsulation aal5snap ! ! interface ATM2/0 no ip address shutdown no at