基于PLC的造纸机控制系统的设计论文.docVIP

目 录 中文摘要 1 英文摘要 2 1 绪 论 3 1.1 造纸机控制系统设计目的与意义 3 1.2 造纸机控制系统的研究现状 3 1.3 本文的主要内容 4 2 造纸机控制系统 5 2.1 造纸机控制系统要求 5 2.2 造纸机控制系统的方案 6 3 控制系统的硬件电路设计 7 3.1 硬件系统组成 7 3.1.1 硬件电路主要器件 7 3.1.2 硬件电路的工作原理 8 3.2系统硬件原理图 12 3.2.1系统电机部分原理图 12 3.2.2 PLC与变频器连接的硬件电路 14 3.2.3 PLC的模块电路 17 4 系统软件设计 21 4.1 系统软件设计的介绍 21 4.1.1 Step7软件内容 21 4.1.2 添加通讯适配器 21 4.2 系统硬件组态与软件编程 22 4.2.1 系统硬件组态 22 4.2.2 软件流程图 22 4.2.3 PLC的软件编程 23 结 论 26 谢 辞 27 参考文献 28 附录1：系统控制原理图 29 附录2：PLC原理图 30 基于PLC的造纸机控制系统的设计 摘 要：?造纸业是与社会文明和经济发展息息相关的基础原材料产业, Design of Paper Machine Control System Based on PLC Abstract：Paper industry is a basic raw material industry which closely linked with the social civilization an economic development. At present, there is a certain gap in automation level between domestic paper industries and abroad. So design of papermaking system is crucial to the paper industry. There is a paper machine control system based on PLC has been designed in this paper. In the system, we use the S7-300 PLC as the control core, the ABB converter as drive unit, three-phase AC motor as execution unit. By PLC through the communication between Profibus-DP network and inverter to complete every transmission point start, stop, acceleration, deceleration, tight etc. And the development process of domestic and international paper industry also introduced in this paper, papermaking machine according to the system control requirements to determine the control scheme. The design of hardware circuit diagram of the control system, introduces its working principle, and the selection of the components, programming software based on Step7 and completed the system’s hardware configuration and control program. the design of the control system of paper machine based on PLC in this paper has advantages of simple structure, low cost, convenient control. Keywords：Paper machine, inverter, the communication control, configuration, Profbus-DP 1 绪 论 1.1 造纸机控制系统设计目的与意义 本次课题主要研究的是基于PLC的造纸机控制系统的设计。通过对造纸机控制系统的研究与设计，我可以了解造纸机传动的工艺要求、各个传