美国标准-钛及钛合金.docVIP

美国标准-钛及钛合金,棒和丝材(英文) Standard Specification for Tantalum and Tantalum Alloy Rod and Wire This standard is issued under the fixed designation B 365;the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses in dicates the year of last reaproval. A superscript epsilon(e)indicates an editorial change since the last revision or reapproval. 1.Scope 1.1? This specification covers unalloyed and alloyed tantalum rod and wire. 1.2? The materials covered by this specification are: 1.2.1??????? R05200,unalloyed tantalum, electron-beam furnace or vacuum-arc melt, or both, 1.2.2??????? R05400,unalloyed tantalum, powder-metallurgy consolidation, 1.2.3??????? R05255,tantalum alloy,90% tantalum 10% tungsten, electron-beam furnace or vacuum-arc meal, or both, 1.2.4??????? R05252,tantalum alloy 97.5% tantalum 2.5% tungsten, electron-beam furnace or vacuum-arc melt, or both, 1.2.5??????? R05240 tantalum alloy ,60% tantalum 40% columbium ,electron-beam furnace or vacuum-arc melt ,or both. 1.3? ?The values stated in inch-pound unties are to be regarded as the standard .The values given in parentheses are for information only. 1.4? ?The following precautionary caveat pertains only to the test methods portion ,Section 13,of this specification: This standard does not purport to address all of the safety problems ,if any, associated with its use, It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 2. Referenced Documents 2.1 ASTM Standards: B 364 Specification for Tantalum and Tantalum Alloy Ingots E 8 Test Methods for Tension Testing of Metallic Materials E 29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications 3. Terminology 3.1 Descriptions of Terms Specific to This Standard: 3.1.1 lot –all material produced from