adc0832数字电压表程序+仿真图.doc

仿真图： /*********************************包含头文件********************************/ #include reg51.h #include intrins.h /*********************************端口定义**********************************/ sbit CS = P3^5; sbit Clk = P3^3; sbit DATI = P3^4; sbit DATO = P3^4; sbit P20=P2^0 ; /*******************************定义全局变量********************************/ unsigned char dat = 0x00; //AD值 unsigned char count = 0x00; //定时器计数 unsigned char CH; //通道变量 unsigned char dis[] = {0x00, 0x00, 0x00}; //显示数值 /*******************************共阳LED段码表*******************************/ unsigned char code tab[]={0xc0,0xf9,0xa4,0xb0,0x99,0x92,0x82,0xf8,0x80,0x90}; char code tablewe[]={ 0xfd,0xfb,0xf7,0xef,0xdf,0xfe }; /**************************************************************************** 函数功能:AD转换子程序 入口参数:CH 出口参数:dat ****************************************************************************/ unsigned char adc0832(unsigned char CH) { unsigned char i,test,adval; adval = 0x00; test = 0x00; Clk = 0; //初始化 DATI = 1; _nop_(); CS = 0; _nop_(); Clk = 1; _nop_(); if ( CH == 0x00 ) //通道选择 { Clk = 0; DATI = 1; //通道0的第一位 _nop_(); Clk = 1; _nop_(); Clk = 0; DATI = 0; //通道0的第二位 _nop_(); Clk = 1; _nop_(); } else { Clk = 0; DATI = 1; //通道1的第一位 _nop_(); Clk = 1; _nop_(); Clk = 0; DATI = 1; //通道1的第二位 _nop_(); Clk = 1; _nop_(); } Clk = 0; DATI = 1; for( i = 0;i 8;i++ ) //读取前8位的值 { _nop_(); adval = 1; Clk = 1; _nop_(); Clk = 0; if (DATO) adval |= 0x01; else adval |= 0x00; } for (i = 0; i 8; i++) //读取后8位的值 { test = 1; if (DATO) test |= 0x80; else test |= 0x00; _nop_(); C