RBS200的各种电源的有关连线及测试.docVIP

Power Supply 230V AC 4.1 Rectifier BML 435 002/? PSU Input data Mains voltage, single phase -nominal 230V AC -normal voltage variation 208-240V AC(230v±30) -permissible voltage variation 176-264V AC Input current, r.m.s. value 8 A Power factor (50 ?100% load) 0.98 Efficiency (50 ?100% load) 0.85 Recommended mains fuse 16 A Frequency range 45-65 Hz Output data Nominal voltage +24V DC Normal voltage +23 to +28.5V DC Output 1200 W Output current nominal at 24 V 50 A at 27 V 44.4 A 4.2 Power Control Unit ROA 119 807, PCU Input voltage, nominal +24V DC tolerance range +19 to+31V DC Communication interface Opto one-way series bus, baud rate 19200 baud. Digital outputs 7 change-over potential-free contacts Undervoltage alarm 1 +22V Undervoltage alarm 2 +19V Overvoltage alarm +30V to +32V ALARM: Exali boards conector A is connect the top of cabinet connect fields B1, Exali boards conector B is connect the top of cabinet connect fields B2 via a back-open type connector., There are ACU and PCU alarm,only one PCU in the three Cell.the PCU is located Cell A. Cell A S ACU alarm is connect directly exali boards b1,PCUs alarm is connect directly exali boards b3b4,and then the connect field B2 connect the DF. Cell B S ACUS alarm is connect b1 position corresponding to cell As exali board located , and then the connect field B2 connect the DF. Cell C is same as Cell B. Power Supply -48V DC 4 Technical data for PSU BMR 960 009/1 4.1 Input data 4.1.1 Input voltage -48/-60V positive ground. Range -38V to -72V with no reduction of performance. Overvoltage -72V to -80V. 4.1.2 Input current Normal operation 35A r.m.s. 1300 W. Battery fuse The converter shall be fed by a 50 A circuit breaker with a break capacity of 4500 A. 4.2 Output data 4.2.1 Output power Output power 1300 W. Output current 48.0 A 4.2.2 Output voltage +27.3V _ 0.1V at Iout=25 A. Adjustment range _ 1.0V by a trim potentiometer positioned on the front. ALARM: Exali boards conector A is co