详述SDH原理教学幻灯片.pptVIP

告警说明和错误代码 Alarm / Error Detection criteria LOS Loss of Signal Drop of incoming optical power level causes high bit error rate OOF Out of Frame A1, A2 incorrect for 3 625 μs LOF Loss of Frame If OOF persists for 3 3ms (to be defined) RS BIP Error 再生段 BIP Error (B1) Mismatch of the recovered and computed BlP-8 Covers the whole STM-N frame RS-TIM 再生段 Trace identifier Mismatch Mismatch of the accepted and expected Trace Identifier in byte J0 MS BIP Error 复用段 BIP Error (B2) Mismatch of the recovered and computed N x BIP-24 covers the whole frame, except RSOH MS-AIS 复用段 AIS K2 (bits 6, 7, 8) = 111 for 3 3 frames MS-REl 复用段 Remote Error Indication Number of detected B2 errors in the sink side encoded in byte M1 of the source side MS-RDI 复用段 Remote Defect Indication K2 (bits 6, 7, 8) = 110 for 3 z frames (z = 3-5) AU-AIS Administrative Unit AIS All 1 in the AU pointer bytes H1, H2 AU-LOP Administrative Unit Loss of Pointer 8 to10 NDF enable, 8 to 10 invalid pointers HP BIP Error HO Path BIP Error (B3) Mismatch of the recovered and computed BIP-8 Covers entire VC-3 HP-UNEQ HO Path Unequipped C2 = 0 for 3 5 frames HP-TIM HO Path Trace Identifier Mismatch Mismatch of the accepted and expected Trace Identifier in byte J1 HP-REI HO Path Remote Error Indication Number of detected B3 errors in the sink side encoded in byte G1 (bits 1, 2, 3, 4) of the source side HP-RDI HO Path Remote Defect Indication G1 (bit 5) = 1 for 3 z frames (z = 3, 5 or 10) HP-PLM HO Path Payload Label Mismatch Mismatch of the accepted and expected Payload Label in byte C2 TU-LOM Tributary Unit Loss of Multiframe H4 (bits 7, 8) multiframe not recovered for X ms X = 1 to 5 ms TU-AIS Tributary Unit AIS All 1 in the TU pointer bytes V1, V2 TU-LOP Loss of Pointer 8 -10 NDF enable, 8-10 Invalid pointers LP BIP LO Path BIP Error Mismatch of the recovered and computed BIP-8 (B3) or BIP-2 (V5 bits 1, 2). Covers entire VC-n LP-UNEQ LO Path Unequipped VC-3: C2 = 0 for = 5 frames, VC-m