GE-Ohmeda IWS 婴儿抢救台 Service Manual-7.pdfVIP

Appendix Elapsed timer 60 minute elapsed timer with hold mode and Apgar tones. Manual mode heat selector range All HCA and HCC units and Model 5000: 0 to 540 watts in 20 increments of 5% each. Models without HCA or HCC serial numbers: 0 to 440 in 20 increments of 5% each. Servo mode control range 35.0 to 37.5°C in increments of 0.1°C (all models except the 2001 international) Alarms Multiple audio tones: Operator prompt tone. Alternating single tone. Alternating two tone. Overhead Alarm Light Large alarm light located on the front of the heater assembly for easy visual identification. Probe Failure Alarm The alternating two tone alarm is active only in the servo mode. Activates when the skin temperature probe: 1. Fails electrically due to an open or short circuit, or 2. Is disconnected from the Warmer. 3. Probe senses temperature outside the 01 - 50° C range. When this alarm condition exists: 1. The heater is turned off and 2. The patient temperature display flashes “HH.H” or “LL.L”. Note: Temperature is only displayed in the 22.0 - 41.9° C range inclusive. In both the servo and manual modes, temperatures below 22.0° C display “LL.L”, and temperature above 41.9° C display “HH.H”. Temperatures above 50° C cause a blank display in the manual mode. Tem