工艺花瓶的冲模设计毕业设计精选.docxVIP

摘要本次设计的题目是工艺花瓶的冲模设计,体现了冲压零件的设计要求、内容及设计方向,是一次很有意义的设计.在本次设计中主要针对级进模进行设计。首先对冲裁件进行了结构分析,依次确定模具的类型、结构,接着确定模具的冲裁力和相关尺寸参数的计算,以及标准件的选用,最后运用AutoCAD软件进行零件图和装配图的绘制。本次模具设计并不复杂主要采用理论与实践相结合的方式，运用所学理论知识，以及几次课程设计的经验，基于 CAD 软件作图以及所学的模具知识，再阅读大量相关文献资料，教材及新闻背景资料，在辅导老师的指导和帮助下完成本次毕业设计。冲压件是靠压力机和模具对板材、带材、管材和型材等施加外力,使之产生塑性变形或分离,从而获得所需形状和尺寸的工件(冲压件)的成形加工方法。实践证明，模具的设计光靠理论知识远远不够，还要有实际的经验才能设计出更合理的模具。所以我在此写下此论文。关键字： 工艺花瓶 ; 级进模 ; AutoCAD软件AbstractThe topic of this design is the punching die design craft vase, embodies the design requirements of stamping parts, content and design direction, is a very meaningful design. In this design is aimed at progressive die design. First hedge cutting structure analyses, in turn determine the type, structure of the mould, then determine the mould size parameters of the cutting force and the related calculation, and the choice of standard parts, by using the software of AutoCAD drawing parts drawing and assembly drawing. The design of the mould is not complex mainly adopts the way of combining theory and practice of learning theory knowledge, experience and a few course design, drawing and learned knowledge of mold based on CAD software, and then read a large number of relevant literature, teaching material and news background, under the guidance of tutor and help to complete the graduation design.Stamping is the use of installed in stamping device (press) on the mold to put pressure on the material to produce a separation or plastic deformation, a processing method to obtain the required parts. Practice proved that mould design theory knowledge alone is not enough, must have the practical experience to design a more reasonable mould. So I am writing this thesis.Key words: progressive die process vase AutoCAD software目录引言1第一章工艺花瓶的工艺设计31.1工艺花瓶的轴测图及三视图31.2工艺花瓶的工艺分析41.3工艺花瓶的工艺方案选择41.4凸、凹模刃口尺寸计算5第二章相关参数设计72.1 冲裁的排样72.2 各部分工艺力的计算92.3 弯曲力102.4 压力中心的确定122.5 压力机的选取12第三章冲裁模主要零部件设计133.1定位零件的选取133.2卸料零件设计143.3凸、凹模设计143.4 模架的确定18第四章结构零件的设计204.1固定板、垫板的设计204.2