三辊卷板机关键零部件有限元分析教案.docVIP

XX大学 毕 业 设 计（论 文） 设计（论文）题目：三辊卷板机关键零部件有限元分析 学 院 名 称： 专 业： 班 级： 姓 名： 学 号 指 导 教 师： 职 称 定稿日期： 年 月 日 摘 要 有限元分析是用较简单的问题代替复杂问题后再求解。它将求解域看成是由许多称为有限元的小的互连子域组成，对每一单元假定一个合适的(较简单的）近似 解，然后推导求解这个域总的满足条件(如结构的平衡条件），从而得到问题的解。这个解不是准确解，而是近似解，因为实际问题被较简单的问题所代替。由于大 多数实际问题难以得到准确解，而有限元不仅计算精度高，而且能适应各种复杂形状，因而成为行之有效的工程分析手段。 Abstract Finite element analysis is to use simpler problem instead of solving complex problems after. It will solve the field as much as by finite element of small interconnect subfields, each unit is assumed to be a proper ( simple ) approximate solution is derived, then solve the domain satisfying conditions ( such as structural equilibrium conditions ), resulting in the solution of problems. This solution is not accurate solution, but the approximate solution, because the actual problem is simpler problem place. Because most practical problems difficult to obtain accurate solution, and the finite element computation of not only high precision, but also can adapt to a variety of complex shapes, thus become effective engineering analysis method. The design is based on the ANSYS software on the three roller bending machine key components analysis. Compared with the traditional calculations are compared, with the help of computer finite element analysis method can be more efficient and precise results. Set the correct model, dividing the appropriate grid, and set a reasonable solution process, can accurately obtain analysis model of various parts of the stress, deformation and other results. The design and optimization of parts have great reference value. Key Words: bending machine;3D modeling; ANSYS; static analysis 目 录 摘 要 II Abstract III 目 录 IV 第1章 绪论 6 1.1概述 6 1.2卷板机的原理 7 1.2.1