[信息与通信]AN445 Silicon Labs Si4431RF性能及ETSI兼容性测试结果.pdfVIP

AN445 Si4431 RF P ERFORMANCE AND ETSI C OMPLIANCE TEST R ESULTS 1. Introduction The purpose of this application note is to provide measurement results and ETSI compliance results for the Si4431B when operated from 863 to 870 MHz. All tests are performed using an ISM-DK3 kit with a with a 4431-T- B1-B-868 (or DKDB1) TX/RX Split RF Test Card. The Wireless Development Suite (WDS) is used to control the test card. The results can be duplicated by using the same configuration and scripts available on the Silicon Labs website and referenced in the EZRadioPRO® Quick Start Guide. All settings were used directly from the Excel Register Calculator worksheet provided on the Silicon Labs web site. For measurement results with different RF parameters, contact customer support at: /support/pages/contacttechnicalsupport.aspx and register to submit a technical support request. 2. Relevant Measurements to Comply with ETSI In this report the rules of the 300220001v020301 ETSI document are applied. ETSI compliance of the transmitter in the EU pertains to TX frequency error (subclause 7.1), output power (subclause 7.2 and 7.3), emissions and harmonics (subclause 7.8), and transient power (subclause 7.5). When operating under the sub-bands (g1, g2, g3, g4, alarm, etc.), the modulation bandwidth limit (subclause 7.7) is also applied. In narrowband channelized applications, the adjacent channel power (ACP, subclause 7.6) should also be measured. In RX mode, the Si4431 is an ETSI Class 2 receiver. For Class 2 compliance, the following measurements must be checked: blocking (subclause 8.4), sensitivity (subclause 8.1), receiver spurious radiation (subclause 8.6). The Si4431 does not comply with ETSI Class 1 requirements. The compliance with each of the above ETSI measurement points