ATG 電刷 A6.pptVIP

High volume fixtureless test Test flow Test flow 新的测试理论 How it works How it works How it works How it works How it works How it works How it works How it works How it works How it works How it works How it works How it works How it works Basic function sketch The Connector Matrix and Connectors Connector Specification The Contacts for standard Standard Contact Smallest net to be eliminated The Contacts for Package Package contact Package to Standard Contact Principle of electrical scanning Principle of electrical scanning Principle of electrical scanning Principle of electrical scanning Principle of electrical scanning Principle of electrical scanning Principle of continuities Principle of isolations Panel Conditions Test Conditions 资料处理流程 网络连接 Boost your flying prober for a pad smaller than 100 um (0,004“) Eliminator E6 测试过程不需要任何测试资料支持 每片板子都会进行同样的电学扫描测试 电刷会将收集到的讯号以标准格式读入成像分析软件. 成像分析软件生成模拟电学图象 将扫描生成的图象与标准资料进行对比 (IPC and Gerber) 删除不需要测试的open点 删除不需要测试的short点 生成需要飞针测试的网络资料 Eliminator E6 Waiting for the next board Eliminator E6 Continuity check on a high threshold value Eliminator E6 Continuity check on a low threshold value (20 Ohm) Eliminator E6 Isolation, try to load up to e.g. 250V Eliminator E6 Intrabar, try to load contact groups to different potential Eliminator E6 116 um pitch Eliminator E6 Contact to Contact: AB eliminated if A can be charged to voltage Contact to matrix: CD eliminated if C can be charged to voltage Eliminator E6 Working panel的板子,非shipping panel. 板面边缘需要直线平行,无不规则的捞边. 板面内部不能有较大的捞空 最小测试面积: 330mm x 330mm(13“x13“) 最大测试面积: 622mm x 622 mm(24.5“x24.5“) 最小测试板厚: 0.25mm 最大测试板厚: 5mm 板面要清洁,无油污等 必须是 Solder mask以后 Eliminator E6 典型的 20 Ohm 开路测试 典型的 10 –100 MOhm 短路测试 开路测试消除率 85% 短路测试消除率 50% 目标产能 40-60 panels/h Eliminator E6 CAM System Net list extraction Optimize endpoints Generate adjacency Gerber 274x Output Generate 274x layer for top and bottom DPS A6/A5 Data Processing E6 A6 IPC-D356A/E6 剩余测点资料 IPC-D356A Goo