IPC-A-600F 教材.pptVIP

Trimmed Edges/Edge Delamination Target Condition - Class 1, 2, 3 Free of nicks and tears. Minimum edge to conductor spacing maintained. The trimmed edge of the flexible printed wiring or the flexible section of finished rigid-flex printed wiring is free of burrs, nicks, delamination, and tears. 如图中﹐在板边看分层﹐原则上不允许有刻痕﹐缺口﹐ * Trimmed Edges/Edge Delamination Acceptable - Class 1, 2, 3 No nicks or tears in excess of that specified in the procurement documentation. Nicks and tears that occur as a result of tie-in tabs to facilitate circuit removal shall be as agreed on by the user and supplier. Edge to conductor spacing of the flexible portion is within requirements specified on the procurement documentation. Nicks or haloing along the edges of the flexible printed wiring, cutouts, and unsupported holes, providing the penetra-tion does not exceed 50% of the distance from the edge to the nearest conductor or 2.5 mm [0.0984 in], whichever is less. 如左下图﹐简单来说﹐如果PCB有缺陷﹐刻痕﹐但是其距离最近的线路不超过2.5mm﹐就可以被class1,2,3所接受。 * METAL CORE PRINTED BOARDS – Type Classifications Laminated Type Metal Core Board Single conductive layer on both sides and insulated from the metal core substrate. Conductive material to be copper foil an electrodeposited copper. PCB大致分为以下三种﹐左图中为第一种﹐如图所示﹐在一层与一层之间有一层由金属和玻璃纤维够成的物质﹐叫core。 * Type Classifications Laminated Type Metal Core Multilayer Board More than one conductive layer on one or both sides and insulated from the metal core substrate. Conductive material to be copper foil and electrodeposited copper. Insulated-Metal-Substrate Metal Core Board Single conductive layer on both sides and insulated from the metal core substrate. Conductive material to be electroless copper and a copper flash is then applied over all surfaces. From this point on, document printed board fabrication processes are employed. This process is generally limited to double-sided boards only. 和上一页一样﹐左图中是另外两种。 * Spacing Laminated Type Target Condition - Class 1, 2, 3 The spac