热处理对IN783合金组织和拉伸性能的影响-应用昆虫学报.PDF

下半月出版 Material Heat Treatment 材料热处理技术 热处理对IN783 合金组织和拉伸性能的影响 段辉, 甄小辉, 吴锐红 (陕西宏远航空锻造有限责任公司, 陕西 三原 7 13801) 摘 要 对IN783 合金在不同热处理条件下的组织和拉伸性能进行了研究遥 结果表明院在标准热处理态的N783 合 金中袁一次和二次茁 相同时存在袁晶内形成两种尺寸的酌 相遥 在低于 1150 固溶处理后袁晶粒长大速度慢袁一次茁 相逐 渐减 袁二次茁 相析出增加袁 尺寸酌 相稍有增加遥 高温固溶结合水淬处理袁并缩短茁 时效时间袁合金内析出密集细小 的酌 相遥IN783 合金的拉伸强度对晶粒尺寸敏感袁升高固溶温度后袁合金的650 强度逐渐降低袁塑性变化不 遥晶内析 出密集细小的酌 相对合金晶内有强化作 袁使粗晶合金保持了相当的强度遥 关键词 热处理曰IN783 合金曰组织曰拉伸性能 中图分类号 TG 156.9 文献标识码 A 文章编号 Effect of Heat Treatment on Microstructure and Tensile Propertoes of IN783 Alloy DUAN Hui, ZHEN Xiaohui, WU Ruihong (Shanxi HongY uan A v iation Forging Company Ltd., Sanyuan 7 13801, China) Abstract 院The effects of heat treatment on the microstructures and tensile properties of IN783 alloy were studied. The results show that for IN783 alloy with standard heat treatment, both primary and secondary 茁 phases are characterized, and the matrix is precipitated with bimodal 酌忆 phases. When the solution annealing temperature is lower than 1150 , the growth of grain size is slow; the primary 茁 phase is dissolved gradually; while the precipitation of secondary 茁 phase is promoted, the precipitation of large 酌忆 phase is enhanced. High temperature solution annealing then water quenched treatment, with decreasing the 茁 aging time, the matrixi widely precipitated with fine 酌忆 phase. The tensile strength of IN783 alloy is sensitive to grain size, elevating the