小模数弧齿锥齿轮的三维建模与应用分析.PDFVIP

小模数弧齿锥齿轮的三维建模与应用分析 张华 刘髙杰 徐林林 马江民 （河南科技大学 机电工程学院，河南 洛阳 471003） 摘要 针对小模数弧齿锥齿轮，本文提出了一种新的加工组合：小轮采用传统的双面法铣齿加工， 设计大轮齿面加工参数，控制大轮的两齿面分别与小轮齿面相配。根据以上加工方法，设计小模数 弧齿锥齿轮良好啮合的齿面加工参数，并创建齿轮副的精确三维模型。在 UG 软件环境下，可以完 成齿轮副的虚拟装配、干涉检查。本文设计的小模数弧齿锥齿轮的齿面可以保证齿面的良好啮合， 本文完成的三维模型可以应用于小模数弧齿锥齿轮的模具成型加工，如粉末冶金、精锻、注塑等， 为小模数弧齿锥齿轮的精密、高效、节能加工奠定了理论基础。 关键词 小模数 弧齿锥齿轮 三维建模 模具法加工 Small-module spiral bevel gear 3D model and applied analysis Zhang Hua Liu Gaojie Xu Linlin Ma Jiangmin (School of Mechatronics Engineering, Henan University of Science and Technology, Luoyang 471003, China) Abstract For small-module spiral bevel gear, this paper proposed a new machining process. The pinion was adopted traditional double-side machining method. Designing gear machining parameters, the gear two tooth surfaces were controlled separately to suit for pinion tooth surface. According to above machining process, small-module spiral bevel gear machining parameters were designed to fulfill good meshing property, and its accurate 3D model was created. Under UG software environment, the gear virtual assembly and interference checking were completed. In this paper, the small-module spiral bevel gear tooth surfaces were designed to have good meshing property, and the 3D model can be applied for the gear molding machining process, such as powder metallurgy, precision forging, injection molding, etc. The above research provided a theoretical foundation on small-module spiral bevel gear precision manufacturing, which has high efficiency and energy saving characters. Key words Small-module; Spiral bevel gear; 3D model; molding machining process 0 引言 [1] 弧齿锥齿轮因其传动平稳、强度高而广泛应用于高速、重载的相交轴主传动 。小 模数弧齿锥齿轮广泛应