简单的潮流计算本科毕业设计-应用文.docVIP

摘 要 本文，采用 C++软件平台编制潮流程序，采用牛拉法，通过对比两种算法的迭代精度和迭代次数，进而分析得出两种方法的特点。 本文的主要内容就是基于简单电力网络地潮流计算设计结合牛顿拉夫逊法潮流计算采用PQ快速解耦发潮流计算程序完成基于C语言的电力系统潮流计算程序的设计在电力系统在正常运行的情况下通过对电力系统的潮流关键词：C++编程；潮流计算；牛顿-拉夫逊算法； ABSTRACT Electric power network, this article respectively to four node 5 node power network with 30 nodes of power network to carry on the simple electric network power flow calculation, using c + + software platform trend program, with rafa and PQ fast decoupling method created two programs, by comparing the calculation results of two algorithms, iterative precision and the number of iterations, then analysis the characteristics of the two methods of trend of the computer。 Flow calculation of power system is used for monitoring and research on the condition of power system steady state operation basic computing, is the analysis of power system planning and design, operation and basic tools.In order to improve the rapidity and accuracy of electric power network automation system, and make the system can real-time security, system analysis, the trend of the power network change is an important information resources, so the power flow calculation for power network is now an aspect of the development of the power flow calculation. The main content of this article is based on simple network power flow calculation of design, combined with the Newton - Ralph method flow calculation, the PQ fast decoupled power flow calculation program, complete the power system flow calculation based on the C language program design.In the case of a power system in normal operation, through to the trend of the power system (power, voltage, phase Angle, etc.) to the power system network operation state of a particular point in time is described.In this paper, based on the above basic knowledge of network power flow calculation for power system with the design, simulation, and analyzed the result precision of two calculation methods in different scenarios. Key Words:C + + programming；Power flow calculation;