CCNA考题.doc

1. What are two reasons that a network administrator would use access lists? (Choose two.) A. to control控制 vty access into a router B. to control broadcast traffic through a router C. to filter过滤 traffic as it passes through a router D. to filter traffic that originates from the router E. to replace替换 passwords as a line of defens防卫e against security incursions侵入 Answer: AC 2. A default Frame Relay WAN is classified as what type of physical network? A. point-to-point B. broadcast multi-access C. nonbroadcast multi-access D. nonbroadcast multipoint E. broadcast point-to-multipoint Answer: C 3. Refer to the exhibit. How many broadcast广播 domains exist in the exhibited topology? A. one B. two C. three D. four E. five F. six Answer: C 4. A single 802.11g access point has been configured and installed in the center of a square office. A few wireless users are experiencing slow performance and drops while most users are operating at peak efficiency. What are three likely causes of this problem? (Choose three.) A. mismatched TKIP encryption B. chednull SSID C. cordless phones D. mismat SSID E. metal file cabinets F. antenna type or direction Answer: CEF 5. Refer to the exhibit. What two facts can be determined from the WLAN diagram? (Choose two.) A. The area of overlap of the two cells represents a basic service set (BSS). B. The network diagram represents an extended service set (ESS). C. Access points in each cell must be configured to use channel 1. D. The area of overlap must be less than 10% of the area to ensure connectivity. E. The two APs should be configured to operate on different channels. Answer: BE  6. The command frame-relay map ip 102 broadcast was entered on the router. Which of the following statements is true concerning this command? A. This command sh