电子控制燃油喷射系统外文.pdfVIP

Available online at ScienceDirect Procedia Engineering 174 ( 2017 ) 773 – 779 13th Global Congress on Manufacturing and Management, GCMM 2016 Electronic Control Fuel Injection System Based on GT-POWER and MotoTron a, a b Chaoyi Wei *, Mengqi Chen , Yinjing Jiang aSchool of Mechanical Engineering, Guangxi University, Nanning and 530004, China bSchool of Vehicle Engineering, Guangxi Technological College of Machinery and Electricity, Nanning and 530004, China Abstract Build the model of LJ465Q engine by GT-POWER software and carry on the simulated operation for getting the basic fuel injection scale, then complete the work of Modeling, code generation, ECU brush writing and calibration by MotoHawk rapid prototyping tool and MotoTune, and test verification and optimal calibration. Experiments show that the research method combining software simulations and hardware experiments reduces the number of bench tests, shortens the development cycles and reduces the development costs. © 2016 The Authors. Published by Elsevier Ltd. © 2017 Published by Elsevier Ltd. This is an open access article under the CC BY-NC-ND license Peer-review under responsibility of the organizing committee of the 13th Global Congress on Manufacturing and Management. (/licenses/by-nc-nd/4.0/). Peer-review under responsibility of the organizing committee of the 13th Global Congress on Manufacturing an