CiscoPassword破解.docVIP

Step-by-Step Procedure Follow these steps in order to recover your password: Attach a terminal or PC with terminal emulation to the console port of the router. Use these terminal settings: 9600 baud rate No parity 8 data bits 1 stop bit No flow control Refer to these documents for information on how to cable and connect a terminal to the console port or the AUX port: Cabling Guide for Console and AUX Ports Connecting a Terminal to the Console Port on Catalyst Switches Connect a Terminal to Catalyst 2948G-L3, 4908G-L3, and 4840G Series Switches If you can access the router, type?show version?at the prompt, and record the configuration register setting. See?Example of Password Recovery Procedure?in order to view the output of a?show version?command Note:?The configuration register is usually set to 0x2102 or 0x102. If you can no longer access the router (because of a lost login or TACACS password), you can safely assume that your configuration register is set to?0x2102. Use the power switch in order to turn off the router, and then turn the router back on. Important Notes: In order to simulate this step on a Cisco 6400, pull out and then plug in the Node Route Processor (NRP) or Node Switch Processor (NSP) card. In order to simulate this step on a Cisco 6x00 with NI-2, pull out and then plug in the NI-2 card. Press?Break?on the terminal keyboard within 60 seconds of power up in order to put the router into ROMMON. If the break sequence does not work, refer to?Standard Break Key Sequence Combinations During Password Recovery?for other key combinations. Type?confreg 0x2142?at the?rommon 1?prompt in order to boot from Flash. This step bypasses the startup configuration where the passwords are stored. Type?reset?at the?rommon 2?prompt. The router reboots, but ignores the saved configuration. Type?no?after each setup question, or press?Ctrl-C?in order to skip the initial setup procedure. Type?enable?at the?Router?prompt. You are in enable mode and should see the?Router#?pr