液晶显示器LCM1602程序设计.docVIP

#include reg51.h sbit LCM_RW=P2^1; //定义引脚 sbit LCM_RS =P2^0; sbit LCM_E =P2^2; #define LCM_Data P1 #define Busy 0x80 //用于检测 LCM 状态字中的 Busy 标识 void WriteDataLCM(unsigned char WDLCM); void WriteCommandLCM(unsigned char WCLCM,BuysC); unsigned char ReadDataLCM(void); unsigned char ReadStatusLCM(void); void LCMInit(void); void DisplayOneChar(unsigned char X, unsigned char Y, unsigned char DData); void DisplayListChar(unsigned char X, unsigned char Y, unsigned char code *DData); void Delayms(unsigned int n); void dellay(unsigned int h); unsigned char code Speed[] = { Step/Sec}; unsigned char code State_In_Service[] = {SIS:Step_By_Step}; unsigned char code charactor[]={0,1,2,3,4,5,6,7,8,9,.}; void main(void) { //Delay400Ms(); //启动等待，等 LCM 讲入工作状态 unsigned int a=0,b=6,c=7,i=2; LCMInit(); //LCM 初始化 DisplayListChar(0, 0, State_In_Service); DisplayOneChar(i++,1,charactor[a]); DisplayOneChar(i++,1,charactor[b]); DisplayOneChar(i++,1,charactor[c]); DisplayListChar(i, 1, Speed); i=0; while(1); } //写数据 RS=H,RW=L,D0~D7=数据,E=高脉冲 void WriteDataLCM(unsigned char WDLCM) { dellay(100); LCM_E = 0; LCM_RS = 1; LCM_RW = 0; LCM_Data = WDLCM; //dellay(100); //短暂延时，代替检测忙状态 //ReadStatusLCM(); //检测忙 LCM_E = 1; LCM_E = 0; } //写指令 RS=L,RW=L,D0~D7=指令码,E=高脉冲 void WriteCommandLCM(unsigned char WCLCM,BuysC) //BuysC 为 0 时忽略忙检测 { //if (BuysC) ReadStatusLCM(); //根据需要检测忙 dellay(100); //短暂延时，代替检测忙状态 LCM_E = 0; LCM_RS = 0; LCM_RW = 0; LCM_Data = WCLCM; LCM_E = 1; LCM_E = 0; } //读数据 RS=H,RW=H,E=H unsigned char ReadDataLCM(void) { LCM_RS = 1; LCM_RW = 1; LCM_E = 1; return(LCM_Data); } //读状态 RS=L,RW=H,E=H unsigned char ReadStatusLCM(void) { LCM_Data = 0xFF; LCM_RS = 0; LCM_RW = 1; LCM_E = 1; //while (LCM_Data Busy); //检测忙信号 return(LCM_Data); } void LC