[信息与通信]TD-SCDMA典型业务信令流程.ppt

In order enable the transmission of Update IMSI Attach procedure related CN siganling messages, the state of the RRC connection in UTRAN is changed for the duration of the CN signaling message exchange to either cell_FACH or cell_DCH state. Which state is used is decided by the network. After Location Update IMSI Attach the location of the UE is know on Location / Routing area level UE is ready to make mobile originated calls (MOC) or UE is ready to receive mobile terminated calls (MTC) The RRC connection state of the UE is changed back (after certain period) to the idle mode The establishment of the circuit switched call can initialized either by UE I.e. mobile originated call (MOC) or by the network I.e. the mobile terminated call (MTC) On both cases the signaling data must be exchanged not only between CN and UE but also UTRAN and the UE. In UTRAN this means that the state of the UE needs to be changed */68 URA更新流程 UE Target RNC 5.CCCH: URA Update Confirm Source RNC 2.Uplink Signalling Transfer Indication Serving RNC [ new C-RNTI,D-RNTI, UL message] 1.CCCH: URA Update [U-RNTI, URA update cause] RRC-relay RRC 3. Decision Not to perform SRNS relocation RRC RRC-relay RNSAP RNSAP 4. Downlink Signalling Transfer Request RNSAP RNSAP */68 系统间切换流程（UMTS-GSM） MAP/E MAP/E 2. Prepare Handover BSSMAP BSSMAP 4. Handover Reuqest Ack RANAP RANAP 13. Iu Release Complete BSSMAP BSSMAP 3. Handover Request MAP/E MAP/E 5. Prepare Handover Response RANAP RANAP 6. Relocation Command BSSMAP BSSMAP 8. Handover Detect BSSMAP BSSMAP 10. Handover Complete MAP/E MAP/E 11. Send End Signal Request MAP/E MAP/E 14. Send End Signal Response RANAP RANAP 1. Relocation Required UE Node B RNC Serving CN MSC BSC BTS RRC 7. DCCH : Inter-System Handover Command RRC RR 9. Handover Complete RR RANAP RANAP 12. Iu Release Command */68 系统间切换流程（ GSM -UMTS） RANAP RANAP 3. Relocation Request BSSMAP BSSMAP 1. Handover Requiied RANAP RANAP 4. Relocation Request Ack MAP/E MAP/E 5. Prepare Handover