深圳新城电子有限公司.docVIP

承认书 SPECTIFICATION FOR APPROVAL 产品名称（DESC）： USB直充 客户名称（CUSTMOER）： 客户编号（CUSTMER P/N）： 产品编号（NUMBER）：TX-037（2.1A-IC方案） 页码（PAGE）: 版本（REV NO）： 编制 PREPARED BY 审核 CHECKED BY 批准 APPROVAL BY 承认 SIGNATURE 审核 CHECKED BY 批准 APPROVAL BY 供方签章： 客户签章： SUPPLIER CUSTOMER 日期： DATE 备注：承认签章后请回复一份（或复印件）给我司，其余由贵司留作存档。如果在签章的承认书（或复印件）未回复我司之前，下了有关此规格产品的定单且又无特别说明，那么我司就确定贵司已完全承认该份承认书了。 Please return one specification or one copy of it with your chop and signature of approval and retain the others for your record .In the event of an order being placed for this part number before the chop and signed with specification (or copy) is returned and without special explanstion,It will be assumed that approval have been given. Switching Power Supply Specifications Table of contents 描述：SCOPE 输入特性：INPUT CHARACTERISTICS 输出特性：OUTPUT CHARACTERISTICS 环境条件：ENVIRONMENTAL REQUIREMET EMC安全要求：SAFETY AND EMI REQUIIREMENT 结构参数：MECHANICAL REQUIRMENT 铭牌附图：LABEL 包装：PACKING 描述（SCOPE）： 本产品适应于世界各地各种标准。This product to adapt to all over the world all kinds of standards. 2、输入特性（INPUT CHARACTERISTICS）：Under voltage protection (UVLO) 内部的UVLO比较器会检测VDD引脚电压，其导通和关断闰值电压被固定为14V和8.8V。启动期间，VDD电压必须通过启动电阻和电容充电到14V以开启芯片，在变压器辅助绕组完全提供能量之前，启动电容将一直为VDD提供电流。UVLO的闰值电压差是为了防止启动过程中的VDD电压下降引起的误触发。Internal UVLO voltage comparator detects the VDD pin, conduction and turn-off leap value voltage is fixed and 14V. Start During the VDD voltage must be initiated through resistors and capacitors charge to 14V to open chip, fully of the transformer secondary winding can provide Before the amount, will provide VDD with start capacitor current. UVLO leap value VDD voltage difference is to prevent the startup process Pressure drops causing false triggering. 输出特性（OUTPUT CHARACTERISTICS）：Current detection and over-current limit CL2263采用了峰值电流模控制来调节输出电压，并逐周期限流保护。通过检测连接于CS端的电阻上的电压来检测开关峰值电流，而占空比的大小取决于电流采样信号以及反馈电压VFB，电流采样的闰值电压设为0.75V，如果CS端电压大于0.75V，内部比较器会触发信号并关断功率MOS管。CL22