MacBook Core 2 Duo 光驱拆卸.pdf

MacBook Core 2 Duo 光驱拆卸 Upgrade or replace the combo or SuperDrive (requires a slim drive). Be sure to determine which model Macbook you have when installing new parts because earlier models have a PATA/IDE connection to the motherboard rather than SATA. 升级或更换组合或 SuperDrive 驱动器（需要苗条驱动器）。因为较早的机型有 PATA/ IDE 连 接而比 SATA 的主板是哪个型号的 MacBook ，你必须安装新的部件时，一定要确定。 Step 1 — Battery ¶ • Use a coin to rotate the battery-locking screw 90 degrees clockwise. 第 1 步 - 电池¶ •使用一个硬币将电池锁螺丝顺时针旋转 90 度。 1 Step 2 ¶ • Lift the battery out of the computer. 第 2 步¶ •抬起电池后从计算机中取出电池。 2 Step 3 — Memory Cover ¶ • Unscrew the three evenly-spaced Phillips screws from along the rear wall of the battery compartment. • The screws are captive to the metal memory cover so you cannot lose them. 步骤 3 - 内存盖¶ •将三个均匀间隔的菲利普斯螺丝从电池仓的后墙拧下。 •金属内存盖螺丝是圈住的，所以你不能失去他们。 3 Step 4 ¶ • Rotate the L-shaped memory cover so it clears the battery compartment opening and lift it up and out of the computer. 步骤 4¶ •将 L 形的内存盖卸下来。 4 Step 5 — Upper Case ¶ • Remove the following 3 screws: o One 1 1 mm Phillips#00 in the middle of the case. (Head: 5mm dia. x .75mm thick) o Two 14.5 mm Phillips #00 (Head: 5mm dia. x .75mm thick) • If the screws stick in the case, you can use a magnetized screwdriver to draw them out. • The shorter of the three screws goes in the middle. 第 5 步 – 上盖（键盘） •拆卸以下 3 个螺丝： o 一个在中间的 11 毫米飞利浦#00 十字螺丝。 （头部：5mm 直径×0.75 毫米厚） o 两个 14.5 毫米飞利浦#00 十字螺丝。（头部：5mm 直径 x0.75 毫米厚） •如果螺丝陷住，你可以使用磁化的螺丝刀来吸出他们。 •较短的三个螺丝在中间。