毕业设计（论文）-虹吸滤池工艺给水工程设计_精品.docVIP

虹吸滤池工艺给水设计 xxx （师范大学环境工程学院xx级xxx班) 指导教师:xx（xxx） 摘要: 本次设计为虹吸滤池工艺给水工程设计，设计内容主要包括三部分，即给水处理工艺流程设计（包括虹吸滤池）、个单体构筑物的工艺设计和泵站、泵房工艺设计。根据设计资料，本次设计取水水源为地表河流水，该河流水质较好，符合Ⅱ类水源水的水质指标。本次设计所采用的净水工艺流程为：原水——混凝沉淀——过滤——消毒。混凝包括混合和絮凝两部分。混合是在静态混合器中投加聚合氯化铝，絮凝设备选用回转式隔板絮凝池，选用平流沉淀池进行沉淀，过滤设备采用虹吸滤池，最后投加液氯进行消毒。水泵和泵房的设计中，给水泵选用离心泵，采用排水泵排水。水厂总占地面积，因地制宜并考虑到远期发展，水厂的工艺流程采用L型布置，流程力求简短，适当增加绿地，使水厂立面丰满。最后进行各项工艺的详细计算，并达到设计所需各项要求。 关键词 :水厂；水质模拟；虹吸滤池；平流沉淀池；处理工艺 Siphon Filter Process Water Supply System Zhang Qiannan （Class Grade07 in College of Environmental Engineering，Jilin Normal University，JilinSiping136000） Directive teacher: Chi He(xxx) ABSTRACT :The filter is designed to siphon water supply engineering design process, design mainly includes three parts, namely, water treatment process design (including Siphon Filter), a single process design structures and pumping stations, pumping stations, process design.According to design information, design of water in this river water to the surface water, the river water quality is good, in line with Class Ⅱ water quality source water.The design used in water purification process: raw water - coagulation - filtration - disinfection.Coagulation and flocculation including mixed two parts.Mixed in static mixer in the PAC dosing, flocculation equipment selection rotary separator flocculation, sedimentation tanks used for advection precipitation, filtration equipment used to siphon filter, and finally adding liquid chlorine for disinfection.The design of pumps and pumping stations, to the selection of centrifugal pumps, the use of drainage pump drainage.The total area of ??water, according to local conditions and taking into account long-term development, process water treatment plant by L-type layout, the process be short, due to increase green space, the water elevation of fullness.Finally, the detailed calculation of the process and the requirements to meet the design requirements.