Screw designs in injection molding – Technical Information：注塑螺杆设计–技术信息浅析.pdfVIP

Technical Information Screw designs in injection molding The classical three-section screw Homogeneity may be improved can be employed with adequate by means of additional shear and quality for the processing of many mixing sections. thermoplastics. Efficient optimization of screw When demands on throughput geometry taking the many mutu- performance and molding qual- ally interacting parameters into ity rise, however, the three-section consideration is possible by means screw comes up against its limits. of computer simulations. If requirements with regard to BASF possesses on the one hand throughput and melt homogeneity a suitable simulation program and are high double- and multiple- on the other hand has many years flighted screws and also barrier of experience in the optimization screws afford significant advantages. and use of screws.  Optimized injection molding plastification units In injection molding technology today conventional reciprocating screw injection units are employed almost exclusively. For the processing of On account of the numerous tasks and demands to be fulfilled the thermoplastics these are frequently equipped with a single-flighted design and optimization of injection molding plastification units is an three-section screw (Figure 1). As the name already implies this type optimization problem with a number of objectives. At the same time of screw is characterized by the division of the screw into three dif- the individual va