检查调整气门间隙.pptVIP

7、检查空气滤清器滤芯Check the air filter element 注意：决不允许在没有空滤器时使用发动机 , 否则灰尘和杂质进入柴油机会导致发动机早期磨损。 Note： lt is not allowed to use the engine without air filter，otherwise the dust and impurity will cause early wearing of the engine. 从空滤器中拆下空滤芯，轻 拍端面使灰尘落下，也可用压缩 空气反吹 ( 由内向外吹 )。 Remove the filter core from the air filter element and beat　the side of the element lightly to make dust fall down, or blow the element backward (blow back from inside to outside) by compressed air． 第 *页 共 页 7、检查空气滤清器滤芯Check the air filter element 注意： Note： ·不得吹破滤纸 ·Dont blow off the air filtering Paper 不得用水和油清洗滤纸 ·Dont clean the air filtering　 paper by water and oil ·不得用力拍打或敲打滤芯 ·Dont beat the core forcibly． 第 *页 共 页 8、检查调整气门间隙 Check and adjust valve clearance 检查调整气门间隙 Check and adjust the valve clearance 13mm 套筒扳手 Tool：1 3mm sleeve wrench 拆下 6 个气缸盖罩 Disassemble 6 cylinder head covers 32mm 盘车扳手 Tool: 32mm wrench for turning the crankshaft 用盘车扳手慢慢转动柴油机 使飞轮壳上刻线对准飞轮上的 OT刻度线，此时使第一缸活塞处于压缩行程的上止点位置 ( 一缸进排气阀处于关闭状态 ) Turn the flywheel until its OT scale and the mark on its housing are aligned, push the piston to the position of TDC of compression stroke of 1st cylinder (the intake and exhaust valve of 1st cylinder are closed)． 第 *页 共 页 8、检查调整气门间隙 Check and adjust the valve clearance 塞尺 Tool：Clearance guage 进气门间隙 0.30mm The clearance of intake valve is 0.30mm 排气门间隙 0.40mm The clearance of exhaust valve is 0.40mm WEVB 系统间隙 0.25mm The Clearance of WEVB system is 0.25mm 注意：检测气门间隙时，柴油机应为冷态一一低于 60℃，塞尺在气门杆顶和摇臂间滑动时,有阻滞发粘感觉时，所测间隙值为准确值。 Note: When check the clearance of valve，the engine should be at the cool condition—its temperature is less than 60℃.When the clearance guage glides between the top of valve rod and rocker arm and can be felt retarded and sticky，the　measuring result is proper． 第 *页 共 页 8、检查调整气门间隙 Check and adjust valve clearance 采用 WEVB 系统后，排气门间隙的调整方法 ( 零件序号参见图 1)： After WEVB system is used, the a