拉法基水泥集团--设备调试说明17.docVIP

Test Commissioning No Load Test: Individual Equipment Dust collector No of pages / Equipment Item: Issue Date: 10th Oct., 2008 Rev: R01 Item N° Sheet No. MPT - Single Machine Electrical Protection Interlock Test; MPT - 单机设备保护联锁测试 Check of lubrication and others prior to start 润滑和启动前检查 Lubrication 润滑 All parts are filled with lubricants correctly prior to start. And the lubrication label shall be put up nearby. (check the label’s correctness with the QCP lubrication schedule) 在启动前，所有的部件已经正确添加了润滑油。并且已润滑标签应当贴在润滑点附近。 油脂 Bearing of fan and fan motor, the rotary feeder (if any) 收尘风机及电机，回转下料器（如果有）的轴承 Oil Bearings of fan (if any). 风机轴承润滑油滑润（如果有） □ □ □ Safety Check 安全检查 No inside the de-duster and dust; 检查所有的压缩空气管已连接好 All safety device are installed and functioning; 所有安全防护装置安装到位 Safety signs and danger tape must be put up 所有安全安装到位 □ □ □ Mechanical check and adjustment 机械检查和调整 Check the deduster fans and motors for the tightness of their anchor bolts, check the connection of coupling; 检查收尘风机及电机地脚螺栓是否紧固，联轴器已连接好 No debris inside the de-dusters, bag filter and dust. Close all inspection doors/holes; 检查收尘器内部无杂物，关闭所有的检查孔门 Open the valve at the inlet air pipe, check and adjusting the pressure of compressed air before de-duster. Air pressure must be = 5bar 打开进气管路阀门Check the rotary feeder(if have) normal operation 检查回转下料器（如果有）转动是否灵活 Check the flap valve (if have) for normal operation (the position of the counter-weight should allow the flap to swing back to closed position after discharging material) 检查重垂翻板阀（如果有）动作是否灵活，重垂位置是否合理 Water cooled fan bearings (if any), ensure that the water flow is sufficient. 如果水冷却轴承，检查水流量是否足够 □ □ □ □ □□ □ □ □ Contents of inspection for individual test 单机试车期间检查内容 The duration of individual test should be 单机试车运转时间为The dust collector test must be done with the fan in operation to check leakage and DP pressure 收尘器必须在收尘风机正常工作时进行，并检查是否漏风或检查收尘器差压 4hours 4小时□ Following items should be c